Innovative 3d printed solutions for the modern RC Rock Crawler
The Mullet : straight axles in the front, portals in the back.
Gearing: 17t input, 39t front, 29t rear.
Output shafts: counter rotation
Intended for use with Axial's family axles (ar44,ar45,f9 portal)
Skid plate is 78mm wide compared to 84mm for ODT v1.
Features angled skid plate for chassis with sporty lean.
The Mullet Transmission is backwards compatible with ODT V1 hardware and skid plate.
ODT 3 gear mullet transmission
78mm angled skid plate for the 3 gear ODT
54t 32p spur gear with slipper eliminator.
9t pinion gear 32p
Flipped mullet turns the transmission around and puts the motor towards the rear. This gives the same gearing as an ODT low, but with counter rotating outputs. 34% OD, does not require portal reduction on one axle.
Transmissions are made to order and may have a 2-3 week lead time (05/20/21).
Salinas Design Concepts (SDC) producing 3D printed performance RC crawler products. Parts are designed and printed in house. Customization request are encouraged. New ideas welcomed. Printed parts are produced on demand. Parts are intended for custom builds and may require modification to work.